CC4 analogue 360° camera wiring guide

Use this guide for the four-camera T’EYES AHD analogue 360° kit on the CC4. The CC4 Pro digital kit uses different ports and reverse-trigger wiring.

Connect the camera harness

  1. With the head unit powered off, connect the front, rear, left and right AHD cameras to their corresponding leads on the 360° harness. Plug the combined camera harness into port B on the CC4.
  2. Connect the left and right trigger leads to their respective indicator positive signals. Connect the rear trigger lead to the reverse lamp positive signal, as shown in the diagram.
  3. Connect the 360° harness reversing detection lead to the head unit’s G5 reverse-control wire. If G5 is already fed by the CANBUS decoder, have the installer isolate the existing decoder-to-G5 connection and connect the head-unit side of G5 to the 360° reversing detection lead. This lets the indicator triggers switch the panoramic views. Identify G5 on the supplied harness before changing it.

Check the views before finishing

With the vehicle stationary and secured, check that each camera appears in the correct position and that reverse and each indicator trigger the expected view. Calibrate the surround view with the kit’s calibration equipment before relying on it.

Wiring diagram

CC4 analogue 360° camera wiring guide showing camera connections and trigger wiring
Select the diagram to open it at full size.

CC4 analogue 360° camera kit · CC4 Pro digital wiring guide